Installation precautions and maintenance methods for pasta machine?

A noodle machine is a kind of mechanical equipment, to give full play to its performance, it needs to carry out the necessary maintenance. Good maintenance work can extend the service life of the machine and reduce the occurrence of malfunction. A noodle machine is a kind of equipment that mixes flour and water fully in a certain proportion and then rolls the dough with the required toughness and humidity into strips through the relatively rotating pressure rollers. Then what are the installation precautions and maintenance methods of the noodle machine?

　　Installation precautions for noodle machine:

　　1, the noodle machine must be installed on a flat and hard ground, and connected to the ground. The transmission device should be well protected or mounted on the wall to avoid damage caused by transmission.

　　2, Before moving, maintaining, repairing, or servicing the equipment, the power supply must be cut off, otherwise serious personal safety accidents may occur.

　　3, there is LELO hanging machine equipment and the operator's hands with water, please do not operate the electrical buttons, switches, and other original parts, otherwise, it is easy to electrocute; ensure that the plug contact is good

　　4, please do not use the damaged power plug, and do not put the power cord near the heat source, otherwise it may cause electric shock or fire.

　　5、Please cut off the power supply of the pasta machine when it is not used for a long time, otherwise it may cause electric shock or fire.

　　6、Please make sure that the voltage of the motor and the external power supply are matched, and make sure to use the grounding wire to protect the machine from electric leakage.

　　7, the external power supply must support the installation of air switch protection, try forward and reverse, and press the start switch, and if the machine reverses, replace the knife switch thread.

　　8, this noodle machine can not be inverted, cooking oil can not replace the oil. Keep the machine clean after shutting down. There is no remaining dough on each roll.

　　9, other hard debris is strictly prohibited from entering the rolls and gears. Check whether there is any abnormality before the noodle machine is turned on, and deal with the problem in time.

　　10, try to avoid idling operations. If you need to idle, please loosen the scraper of the pressure roller. Poor contact may cause damage to electrical components or even fire.

　　Noodle machine maintenance methods:

　　1, before and after work, check and clean the sundries on the noodle rollers, knives, and countertop. Recycled flour and starch must be filtered through a sieve before use.

　　2, the oiling hole of the noodle knife should be unclogged frequently, and an appropriate amount of lubricating oil should be added once a day. You can choose gear oil 20# machine oil or edible oil; gears and chains should be coated with the appropriate amount of lithium-based grease.

　　3. Regularly check the tightness of the bolts, check the tightness and wear of the common triangle belt, and adjust or replace them in time. The gear oil of the transmission is replaced after three months of factory use and the following year.